Axxess AX-LOC2.4-PRO 2-In/4-Out LOC | Bass Boost

Flexible Factory-Stereo Integration with 2 Inputs and 4 Outputs

The Axxess AX-LOC2.4-PRO is an active line output converter built to add aftermarket amplifiers to factory radios. Its 2-in/4-out layout gives installers more routing flexibility than a basic LOC, while the selectable input impedance, trigger modes, gain controls, noise-isolation options, and rear-channel bass boost make it easier to match the converter to the vehicle and the system.

Key Features

• 2 Inputs / 4 Outputs: Converts factory speaker-level signals for flexible aftermarket amplifier integration.
• 40V Input Handling: Supports up to 40V or 400W at 20k ohms for high-output factory systems.
• Selectable Input Impedance: Choose 20 ohms, 60 ohms, or 20k ohms to match the OEM source.
• Flexible Turn-On Trigger: Select REM, DC, or AUDIO trigger modes.
• Rear-Channel Bass Boost: Adjustable from 0dB to +12dB for additional subwoofer control.
• Independent Front/Rear Gain: Adjust gain from –28dB to +1dB for better system balance.
• Ground and Noise Isolation: Select GND, ISO, or 200-ohm ground settings to help manage installation noise.
• High-Voltage RCA Output: Provides up to 9.5V RMS output at 13.8V.
• Optional AX-RM1 Remote: Add the Axxess remote control for convenient subwoofer-level adjustment.

Specifications

• Model: Axxess AX-LOC2.4-PRO
• Type: Active line output converter
• Input/output configuration: 2 inputs / 4 outputs
• Maximum input level: 40V / 400W at 20k ohms
• Operating voltage: 9V–16V
• Input sensitivity: 0.5V–20V
• Input impedance selection: 20 / 60 / 20k ohms
• Output maximum: 9.5V RMS at 13.8V
• Turn-on trigger: Remote, DC, or audio sensing
• Remote output rating: 500mA
• DC trigger range: 3V–7V
• Signal-to-noise ratio: Greater than 110dB at 6.4V output
• THD+N: Less than 0.01%
• Frequency response: 20Hz–20kHz
• Rear-channel low-pass filter: Less than 250Hz
• Rear-channel bass boost: 0dB to +12dB
• Front/rear gain adjustment: –28dB to +1dB
• Remote: Optional AX-RM1

Why Choose the AX-LOC2.4-PRO?

A factory radio does not need to be replaced just because it lacks RCA outputs. The AX-LOC2.4-PRO creates a practical bridge between the OEM signal and aftermarket amplifiers, with the control needed to handle different factory loads and system designs. The four-output configuration is especially useful when building a system with separate front, rear, or subwoofer amplification.

Installation Notes

Confirm the factory radio's output level, amplifier requirements, trigger method, and available mounting space before installation. Set the input impedance and gain carefully, then use the rear-channel filter and bass boost to match the subwoofer section. Professional installation is available at Best Auto Sound & Security in Central Texas.